Hi fred and others,
I am using a script to automate uak. Works fine until version 5. I had to edit the script to get it to work again, no problem. But in noticed that there was new screen that will ask for an immediately reboot after some malware detection. Is it possible to disable that by commandline switch, because there are other programs that will run after uak.
Thanks
uak
Forum rules
We have no special rules for UVK forums. Just try to be polite and clear in your posts.
Please don't post spam in this forum. Spammers will be banned by IP, e-mail and username.
We reserve the right to delete all posts and ban all users we consider not having respected these rules without warning.
We have no special rules for UVK forums. Just try to be polite and clear in your posts.
Please don't post spam in this forum. Spammers will be banned by IP, e-mail and username.
We reserve the right to delete all posts and ban all users we consider not having respected these rules without warning.
Re: uak
CSM, You can click No in that screen, to reboot later.
One thing we humans have in common is that we are all different. So, if you think you're weird because you're different from everyone else, then we are all weird.
Fred
Fred
Re: uak
CSM, that screen has always been there. There's no switch to cancel it.
One thing we humans have in common is that we are all different. So, if you think you're weird because you're different from everyone else, then we are all weird.
Fred
Fred